MITSUBISHI PAJERO NM – REMOTE Programming

MITSUBISHI PAJERO AM REMOTE

SUITS

Series / BadgeBuild date fromTo
NM Badges GLS06/200010/2002
NP (K76T, K77T) Badges GLX-R06/20022008

Frequency 315 Mhz

Aftermarket Remote. Opens doors remotely (can be self programmed or locksmith)

See our homepage for Car Key Specialists in your area

If in South East Queensland, we can do it for you, call 0401212147 for details.

Programming Instructions For Remote On

2000 TO 2008

Remote Programming

Official Procedure​

All remotes are deleted when programming, so make sure to re program any existing remotes at the same time.

  • Ensure Ignition is switched OFF, and doors are closed.
  • Place a Jumper wire between PIN 1 and PIN 4on the OBD2 connector. This is “Grounding” PIN 1.
  1. With the Jumper in place, press and release the HAZARD LIGHT Button 6 times
  2. The doors will LOCK and UNLOCK, or the indicator lights will flash to confirm learning mode.
  3. Press and release the LOCKbutton on the 1st remote to be programmed.
  4. Within 10 seconds press and release the LOCKbutton on the same remote twice.
  5. The doors will LOCK and UNLOCK, or the indicator lights will flash to confirm successful programming.
  6. For any additional remotes, immediately repeat steps 3 – 5 with the next remote.

NOTE: IF YOU CANNOT GET YOUR CAR INTO PROGRAMMING MODE PLEASE SEEK PROFESSIONAL HELP FROM A LOCKSMITH OR LOCAL KEY SPECIALIST