Programming Instructions for Mitsubishi Pajero AM Remote 2000-2008

25/11/2023   |   Author: admin   |   No comments   |   Categories: Key Programming • keys • Mitsubishi

MITSUBISHI PAJERO AM REMOTE

SUITS

Series / BadgeBuild date fromTo
NM Badges GLS06/200010/2002
NP (K76T, K77T) Badges GLX-R06/20022008

Frequency 315 Mhz

Programming Instructions For Remote On 2000 to 2008 Mitsubishi Pajero

2000 TO 2008

Remote Programming Official Procedure​

All remotes are deleted when programming, so make sure to re program any existing remotes at the same time.

  • Ensure Ignition is switched OFF, and doors are closed.
  • Place a Jumper wire between PIN 1 and PIN 4on the OBD2 connector. This is “Grounding” PIN 1.
  1. With the Jumper in place, press and release the HAZARD LIGHT Button 6 times
  2. The doors will LOCK and UNLOCK, or the indicator lights will flash to confirm learning mode.
  3. Press and release the LOCKbutton on the 1st remote to be programmed.
  4. Within 10 seconds press and release the LOCKbutton on the same remote twice.
  5. The doors will LOCK and UNLOCK, or the indicator lights will flash to confirm successful programming.
  6. For any additional remotes, immediately repeat steps 3 – 5 with the next remote.

NOTE: IF YOU CANNOT GET YOUR CAR INTO PROGRAMMING MODE PLEASE – Try Again

All Posted Remote Programming Procedures have been tried and test by us before / after a vehicle has been programmed.