Toyota Hiace GDH223 – C1203 – Ecm Communication circuit malfunction

Scan tool based repair unlike earlier versions of the same

when the abs has been reset the ABS Module will need to be re calibrated. ( Depending on the year / depends on what they called it ) In our case, TEST Mode need to be activated and the abs must flash and switch ign off and then should be done

Vehicle.

Hyundai Elantra 2011 with ABS/ESP and EPS. 

Symptom and diagnosis.

Read More

*PROGRAMMING EBCM ON VE COMMODORES

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:
EBCM Reprogramming, refer to Service Programming System (SPS).

EBCM Reprogramming

Read More

Commodore ABS part numbers

This week started off as a cracker, had a WK Caprice come in with a Traction control light that was not working, when the button next to the shifter was depressed.

The operation of the VY commodore, when pressing the TRAC button the TRAC OFF should change in the instrument cluster similar to that when pressing the PWR button.

This vehicle did have traction control as the button was present and also the 6 pipes on the ABS pump block where present, but the TRAC button and accelerator retarder did not work, after setting up the Tech2 on to the vehicle, it was found that the Tech2 could not communicate as the coding was wrong, we then set up the scan tool for a commodore V6 and the Tech2 connected we found fault 62 RPM sensor error, checked the RPM and at idle it was 275RPM instead of 650RPM,
Read More